Table of Contents
Advertisement
Chapter 3
Configuring with the Command-Line Interface
This section describes basic configuration, including enabling the interface and specifying IP routing.
Depending on your own requirements and the protocols you plan to route, you might also need to enter
other configuration commands.
Before you begin configuring the interfaces, make sure you:
•
•
Command
Step 1
Router> enable
Password: password
Router#
Step 2
Router# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
Router(config)#
Step 3
Router# ip routing
Router# appletalk routing
Router# ipx routing
Step 4
Router(config)# interface fastethernet 0/0
Router(config-if)#
Step 5
Router(config-if)# ip address 172.16.74.3
255.255.255.0
Step 6
Router(config-if)# appletalk static
cable-range 3-3
Router(config-if)# appletalk zone ZZEth
Router(config-if)# ipx network B005
Step 7
Router(config-if)# exit
Step 8
Router(config)# Ctrl-z
Router#
Configuring Asynchronous/Synchronous Serial Network
Modules or WAN Interface Cards
You can configure the serial interfaces on your asynchronous/synchronous serial network module or
WAN interface card manually by entering Cisco IOS commands on the command line. This method,
called configuration mode, provides the greatest power and flexibility.
OL-1957-03
Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards
Connect a console to the router.
Power on the router.
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Purpose
Enter enable mode. Enter the password.
You have entered enable mode when the prompt
changes to
.
Router#
Enter global configuration mode. You have
entered global configuration mode when the
prompt changes to
Router(config)#.
Enable routing protocols as required for your
global configuration. This example uses IP
routing, AppleTalk routing, and Internetwork
Packet Exchange (IPX) routing.
Enter interface configuration mode. You have
entered interface configuration mode when the
prompt changes to
Router(config-if)#.
Assign an IP address and subnet mask to the
interface.
Configure routing protocols on the interface. You
must have previously enabled these protocols as
part of global configuration. In this example,
AppleTalk and IPX are being configured on the
interface.
Exit back to global configuration mode.
Repeat Step 4 through Step 6 if your router has
more than one interface that you need to
configure.
When you finish configuring interfaces, return to
enable mode.
3-5
Hide quick links:
Advertisement
Table of Contents
