Cisco 2611XM Software Configuration Manual page 49

Chapter 2 Using the Setup Command Facility
Table 2-1
Country
North America
When you reach the following prompt on the System Configuration Dialog, enter an ISDN switch type
from Table
BRI interface needs isdn switch-type to be configured
Valid switch types are:
Choose ISDN BRI Switch Type [2]:
Do you want to configure BRI0/0 interface? [yes]:
Some encapsulations supported are
Choose encapsulation type
Note The following sections describe the prompts for each encapsulation type. No further configuration is
needed for HDLC encapsulation.
Do you have a service profile identifiers (SPIDs) assigned? [no]: y
Enter SPID1: 12345
Enter SPID2: 12345
The setup command facility only prompts for the SPID number if you specify basic-5ess, basic-ni1,
Note
or basic-dms100 for the switch type.
Do you want to map the remote machine's IP address in dialer map? [yes]:
IP address for the remote interface: 2.0.0.1
Do you want to map the remote machine's IP address in dialer map? [yes]:
IPX address of the remote interface: 40.0060.34c6.90ed
To get to 2.0.0.1 we will need to make a phone call.
Please enter the phone number to call: 1234567890
Configure IP on this interface? [yes]:
If your router has at least one configured LAN interface, you can choose to use an unnumbered IP
Note
address on the interface.
Configure IP unnumbered on this interface? [no]: y
Assign to which interface [Ethernet0/0]:
OL-1957-03
ISDN Switch Types (continued)
ISDN Switch Type
basic-5ess
basic-dms100
basic-ni1
2-1:
[0] none..........Only if you don't want to configure BRI.
[1] basic-1tr6....1TR6 switch type for Germany
[2] basic-5ess....AT&T 5ESS switch type for the US/Canada
[3] basic-dms100..Northern DMS-100 switch type for US/Canada
[4] basic-net3....NET3 switch type for UK and Europe
[5] basic-ni......National ISDN switch type
[6] basic-ts013...TS013 switch type for Australia
[7] ntt...........NTT switch type for Japan
[8] vn3...........VN3 and VN4 switch types for France
ppp/hdlc/frame-relay/lapb/x25
[ppp]:
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Interface Parameters
Description
AT&T basic rate switches
NT DMS-100 basic rate switches
National ISDN-1 switches
2-13