Viewing The Configuration - Cisco 2611XM Software Configuration Manual

Configuring Global Parameters
Step 3 When the following message appears, press Return to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Ethernet0/0
Serial0/0
BRI0/0
Serial0/1
Serial0/2
Step 4 Enter a host name for the router (this example uses 2600):
Configuring global parameters:
Enter host name [Router]: 2600
The enable secret is a password used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 5

viewing the configuration:

Enter enable secret: xxxx
The enable password is used when you do not specify an enable secret password, with some
older software versions, and some boot images.
Step 6 Enter an enable password that is different from the enable secret password. This password is not
encrypted (less secure) and can be seen when viewing the configuration:
Enter enable password: guessme
The virtual terminal password is used to protect access to the router over a network
interface.
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 7
other than the console port:
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 8
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure LAT? [no]:
Configure AppleTalk? [no]:
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Note
Configure CLNS? [no]:
Configure IPX? [no]:
Configure Vines? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
Configure bridging? [no]:
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-4
IP-Address
unassigned
unassigned
unassigned
unassigned
unassigned
Your IGRP autonomous system number [1]: 15
If you answer no to IGRP, you are prompted to configure RIP.
OK? Method Status
NO unset up
NO unset up
NO unset up
NO unset up
NO unset up
Chapter 2 Using the Setup Command Facility
Protocol
up
down
up
down
down
OL-1957-03