Entering The Rom Monitor Mode; Configure; Verify - Cisco 2611XM Software Configuration Manual

Using the ROM Monitor
This appendix describes the ROM monitor (also called the bootstrap program), which is the firmware
that runs when you power on or restart the Cisco 2600, Cisco 3600 and Cisco 3700 series router. During
normal operation, the ROM monitor helps to initialize the processor hardware and boot the operating
system software. You can also use the ROM monitor to help you isolate or rule out hardware problems
encountered when installing your router.
This appendix contains the following sections:
•
•
•
•
•

Entering the ROM Monitor Mode

To use the ROM monitor, you must have access to the console port. See the Cisco 2600 Series Cabling
and Setup Quick Start Guide for information on connecting the console cable.
To enter the ROM monitor mode, do the following:

Configure

Step 1
Step 2

Verify

To verify that you are in the ROM monitor mode, check that the prompt displayed on your screen is the
ROM monitor mode prompt:
rommon # >
OL-1957-03
Entering the ROM Monitor Mode
ROM Monitor Commands
ROM Monitor Syntax Conventions
Command Descriptions
Procedures for Recovering Boot and System Images
Command or Action
2600> reload
Press the Break key during the first 60
seconds while the system is starting up
The is the line number and increases incrementally at each prompt.
#
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
A P P E N D I X
Purpose
Restart the router.
Forces the router to stop booting
and enter the ROM monitor mode.
C
C-1