Cisco 2611XM Software Configuration Manual page 39

Chapter 2 Using the Setup Command Facility
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-JS-M), Version 11.3(2)XA,
PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1998 by cisco Systems, Inc.
Compiled Tue 10-Mar-98 14:18 by rnapier
Image text-base: 0x80008084, data-base: 0x809CD49C
cisco 2611 (MPC860) processor (revision 0x100) with 24576K/8192K bytes of memory.
Processor board ID 04614954
M860 processor, part number 0 mask 32
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
3 Serial network interface(s)
32 terminal line(s)
DRAM configuration parity is disabled.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
When the following message appears, enter yes to begin the initial configuration dialog:
Step 2
Would you like to enter the initial configuration dialog? [yes/no]:
Note
Note
OL-1957-03
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
--- System Configuration Dialog ---
If you answer no to this message, you are prompted to terminate AutoInstall. AutoInstall is
a procedure that configures a new router based on the configuration of an existing router.
If you terminate AutoInstall, you enter the Cisco IOS software CLI.
The interface numbering that appears in the next step is dependent on the type of
Cisco modular router platform. This example shows a Cisco 2600 series router.
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Global Parameters
2-3