Configuring Interface Parameters; Ethernet Interface Configuration; Fastethernet Interface Configuration - Cisco 2611XM Software Configuration Manual

Configuring Interface Parameters

Configuring Interface Parameters
From this point on in the setup process, the prompts you see vary depending on the network modules
and WAN interface cards in place in your router. The following sections provide examples of the setup
steps for each interface module. Refer to the sections appropriate to your router.
Configuration for network modules includes:
•
•
•
•
•
•
•
•
When you complete the setup steps for your interface modules, go to the
section on page 2-24

Ethernet Interface Configuration

This section contains a sample configuration for the Ethernet interface. Enter the values appropriate for
your router and network. The messages you see may vary.
Do you want to configure Ethernet0/0 interface [yes]:
Configure IP on this interface? [yes]:
Configure IPX on this interface? [no]: y

FastEthernet Interface Configuration

This section contains a sample configuration for the FastEthernet interface. Enter the values appropriate
for your router and network. The messages you see may vary.
Do you want to configure FastEthernet0/0 interface [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [no]: yes
IP address for this interface: 6.0.0.1
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-6
Ethernet Interface Configuration, page 2-6
FastEthernet Interface Configuration, page 2-6
Token Ring Interface Configuration, page 2-7
Serial Interface Configuration, page 2-7
Asynchronous/Synchronous Serial Interface Configuration, page 2-10
ISDN BRI Interface Configuration, page 2-12
E1/T1 ISDN PRI Configuration, page 2-18
E1/T1 PRI Mode, page 2-18
–
E1 Channelized Mode, page 2-18
–
T1 Channelized Mode, page 2-21
–
1-Port, 4-Wire 56-kbps DSU/CSU Configuration Setup, page 2-22
for directions on saving your configuration.
IP address for this interface: 255.255.255.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 1.0.0.0, 8 subnet bits, mask is /8
IPX network number [1]:
Need to select encapsulation type
[0] sap (IEEE 802.2)
[1] snap (IEEE 802.2 SNAP)
[2] arpa (Ethernet_II)
[3] novell-ether (Novell Ethernet_802.3)
Enter the encapsulation type [2]:
Chapter 2 Using the Setup Command Facility
"Completing the Configuration"
OL-1957-03