Configuring with the Command-Line Interface
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure
basic router functionality, including:
•
•
•
•
3-5
•
•
•
•
•
•
•
•
•
•
Configuring the 1-Port HSSI Network Module, page 3-46
•
•
Configuring the Compression Network Module for the Cisco 3600 Series Routers, page 3-49
Configuring the Digital Modem Network Module for the Cisco 3640 Router, page 3-50
•
•
Configuring G.SHDSL on a Cisco Router, page 3-60
Saving Configuration Changes, page 3-65
•
Where to Go Next, page 3-65
•
Follow the procedures in this chapter to configure the router manually, or if you want to
change the configuration after you have run the setup command facility
Facility, page
OL-1957-03
2-1.
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
C H A P T E R
Using the Setup Command
3
3-1