T1 Channelized Mode - Cisco 2611XM Software Configuration Manual

Chapter 2 Using the Setup Command Facility

T1 Channelized Mode

The following is an example of a T1 channelized mode configuration using the setup command facility:
The following framing types are available:
Enter the framing type [esf]:
The following linecode types are available:
Enter the line code type [b8zs]:
T1 is capable of being configured for channel 1-24
Enter number of time slots [24]: 3
Configure more channel groups? [no]: y
Enter number of time slots [21]: 3
Configure more channel groups? [no]: y
Enter number of time slots [18]: 3
Configure more channel groups? [no]: y
Enter number of time slots [15]:
Configure more channel groups? [no]:
The following sections describe the prompts for each encapsulation type. No further configuration is
Note
needed for HDLC encapsulation.
PPP Encapsulation
Would you like to enable multilink PPP [yes]:
Enter a remote hostname for PPP authentication [Router]:
Enter a password for PPP authentication:
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
Note
authentication process, is case sensitive and must match the remote router's password exactly.
Frame Relay Encapsulation
The following lmi-types are available to be set,
when connected to a frame relay switch
Enter lmi-type [2]:
The setup command facility only prompts for the data-link connection identifier (DLCI) number if
Note
you specify none for the Local Management Interface (LMI) type. If you accept the default or specify
another LMI type, the DLCI number is provided by the specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine's IP address to dlci? [yes]:
IP address for the remote interface: 2.0.0.2
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface: 40.1234.5678
OL-1957-03
esf | sf
ami | b8zs
[0] none
[1] ansi
[2] cisco
[3] q933a
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Interface Parameters
2-21