3G Wireless Hwic Leds; Connecting An Antenna With The 3G Wireless Wan Hwic - Cisco 1601 - Router - EN Hardware Installation Manual

3G Wireless HWIC LEDs

R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
3G Wireless HWIC LEDs
The 3G wireless HWIC LEDs are shown in
described in
Table 36
LED
Received Signal
Strength Indication
(RSSI) LED
WWAN LED
(Per PCI Express
Mini-card Wireless
WAN Standard)
Service Type LEDs
(CDMA HWIC)
Service Type LEDs
(GSM HWIC)

Connecting an Antenna with the 3G Wireless WAN HWIC

This section contains the following sub-sections:
•
•
•
•
OL-12853-01
10
Table 36.
3G wireless HWIC LED Description
Description
Off: Low RSSI (under -100 dBm).
Slow Green Blink: Low or medium RSSI (-99 to -90 dBm).
Fast Green Blink: Medium RSSI (-89 to -70 dBm).
Solid Green: High RSSI (-69 dBm or higher).
Solid Yellow: No service or no RSSI detected.
Off: HWIC in reset mode or not powered.
Slow blink: Searching for service.
Solid Green: Active service; no traffic detected.
Fast Blink: Active service, and traffic detected is proportional to blink rate.
1xRTT: 1xRTT is the active service.
EVDO: 1xEVDO is the active service.
Both Off: No service is active. Both On: Both services available.
Note
UMTS: UMTS is the active service.
HSDPA: HSDPA is the active service.
Both Off: Fallback service(GPRS or EDGE) is active.
Note
Wireless Access Devices Safety Guidelines and Warnings, page 11
Prerequisites for Connecting Antennas, page 12
Supported Cisco Antennas and Cables, page 13
Connecting Swivel-Mount Dipole Antennas, page 14
Figure 121 and
If the RSSI LED is solid yellow, it indicates that no service and no RSSI
is detected.
If the RSSI LED is solid yellow, it indicates that no service and no RSSI
is detected.
3G Wireless WAN Interface Cards
Figure 124. The functions of the LEDs are