Cabling For Cisco Interface Cards - Cisco 1601 - Router - EN Hardware Installation Manual

Cabling for Cisco Interface Cards

Cabling for Cisco Interface Cards
The cables required to connect the interface card to the network differ according to interface and
connector type. See
Note Cabling for 1- or 2-slot network modules is determined by the installed interface cards.
For network-end connectors and pinout specifications of the cables connecting the voice cards, refer to
Note
the
Table 2 Cabling for Cisco Interface Cards
Technology
Connector Type, Cable
Connection Type Color
Analog Dialup
300 bps to 33.6 kbps RJ-11, pink
analog dialup
Cable Modem
Cable F
DSL
ADSL RJ-11C/CA11A,
lavender
SHDSL RJ-11C/CA11A,
lavender
RJ-11
RJ-45
Ethernet
Fast Ethernet, copper RJ-45
Fast Ethernet, copper RJ-45
OL-12796-01
12
Table 2 for more information.
Cisco Modular Access Router
Cable
RJ-11 straight-through
CATV coaxial
RJ-11 straight-through
RJ-11 straight-through for 2-wire
RJ-14 straight-through for 4-wire
RJ-11 straight-through
RJ-45 straight-through
100BASE-T Category 5 or above UTP
•
•
Specifications. Look under the type of interface card.
For 10BASE-T operation, use
Category 3, 4, or 5 UTP cable.
For 100BASE-TX operation, use
Category 5 UTP cable.
Cisco Interface Cards for Cisco Access Routers
Use with
WIC-1AM
WIC-2AM
WIC-1AM-V2
WIC-2AM-V2
HWIC-CABLE-D-2
HWIC-CABLE-E/J-2
WIC-1ADSL
WIC-1ADSL-DG
WIC-1ADSL-I-DG
HWIC-1ADSL
HWIC-1ADSLI
WIC-1SHDSL
WIC-1SHDSL-V2
WIC-1SHDSL-V3
HWIC-2SHDSL
HWIC-4SHDSL
WIC-4ESW
HWIC-4ESW
HWIC-4ESW-POE
HWIC-D-9ESW
HWIC-D-9ESW-POE
HWIC-1FE
HWIC-2FE