Cisco 1601 - Router - EN Hardware Installation Manual page 55

Installing Cisco Interface Cards in Cisco Access Routers
If you are replacing an interface card, or if there is a blank interface card faceplate already installed in
Step 7
the MRP or ASI 81 card, use either a number 2 Phillips screwdriver or a small flat-blade screwdriver to
remove the interface card or blank faceplate.
Save the blank faceplate for future use.
Tip
If you remove an interface card while the MRP or ASI 81 is running, the interface card configuration is
Note
lost until the system card reboots.
Align the new interface card with the guides in the ASI 81 or MRP slot, and slide it gently into the slot.
Step 8
(See Figure
Figure 29
Guides
Interface
card
Push the interface card into place until you feel its edge connector seat securely into the connector on
Step 9
the MRP or ASI 81.
Using a Phillips or flat-blade screwdriver, tighten the interface card mounting screws until the interface
Step 10
card faceplate makes contact with the faceplate on the MRP or ASI 81 card.
29.)
Installing Interface Cards into an MRP Card
Installing Cisco Interface Cards on the Cisco ICS 7750
OL-12842-01
23