Cisco 1601 - Router - EN Hardware Installation Manual page 195

Access Point High-Speed WAN Interface Cards
Figure 133
1
HWIC
AP
1
2
3
Access Point HWIC Limitations
Limitations of the single-mode and dual-mode access point HWICs include the following:
•
•
•
•
Access Point HWIC Safety Guidelines and Warnings
The following are guidelines for wireless access devices:
•
•
•
For regulatory information about the access point HWIC, see the
Note
Regulatory Information for Cisco Access Products with 802.11a/b/g and 802.11b/g Radios
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units. Statement 12
Dual-Mode Access Point HWIC Front Panel
2 3
OK
a
DATA
LEFT
5
Mounting screws
RP-TNC connectors
OK LED for the 802.11a radio
Only one access point HWIC is supported in the router at a time. Installation of two access point
HWICs in the router is not supported.
The access point HWIC must be installed in an HWIC slot. To determine which slots on your
platform support HWICs, see the
Cards" section on page 8.
The 4.9-GHz band is not supported.
Although the use of two antennas is not required, both antennas should be used to take advantage of
diversity for the best RF performance.
Do not touch or move antenna(s) while the unit is transmitting or receiving.
Do not hold any component containing a radio so that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
The use of wireless devices in hazardous locations is limited to the constraints posed by the local
codes, the national codes, and the safety directors of such environments.
4 2 1
OK
g
RP
DATA
RIGHT
TNC
6
4 OK LED for the 802.11b/g radio
5 DATA LED for the 802.11a radio
6
DATA LED for the 802.11b/g radio
"Platform Slot Numbering and Limitations for Cisco Interface
Access Point High-Speed WAN Interface Cards
Declarations of Conformity and
OL-12854-01
document.
3