Cisco 1601 - Router - EN Hardware Installation Manual page 150

Supported Platforms
WIC-1ENET Full-Duplex and Half-Duplex
The WIC-1ENET is set to half-duplex mode by default, and it does not autosense the mode of another
device attached to the port. If you set the card to full-duplex operation, you must also set the device to
which the port is attached to full-duplex mode.
Use the full-duplex command to put the Ethernet interface into full-duplex operation. The interface can
be put into half-duplex mode by entering the no full-duplex command.
You can also use the half-duplex command to put the Ethernet interface into half-duplex operation, the
default state of the Ethernet interface.
To verify the interface state, enter a show interface command as follows:
1750#show interface Ethernet 0
Ethernet0 is up, line protocol is up
Hardware is PQUICC Ethernet, address is 0001.64ff.ef6a (bia 0001.64ff.ef6a)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 10BaseT
....
Supported Platforms
For a list of the platforms supported by a Cisco interface card refer to
Interface
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
OL-12849-01
6
reliability 255/255, txload 1/255, rxload 1/255
Cards.
LAN Interface Cards
Platform Support for Cisco