Cisco 1601 - Router - EN Hardware Installation Manual page 38

Installing Cisco Interface Cards in Cisco Access Routers
Table 5 Interface Card Hardware Installation Tasks for Cisco Access Routers
For All Cisco Access Routers Except Cisco 2800 and
Cisco 3800 Series Routers
Step 4
Install blank faceplates where appropriate. (See the
"Removing Blank Faceplates" section on page
Step 5 —
Note Do not install an ISDN BRI WAN interface card or an ISDN BRI network module in the same chassis
as an ISDN PRI network module.
Tools and Equipment Required During Cisco Interface Card Installation
You will need the following tools and equipment while working with Cisco interface cards:
•
•
•
•
Tip
Preparing Cisco Router Slots for Interface Card Installation
Several Cisco access routers have flexible interface card slots to support both single-wide and
double-wide interface card form factors. Before installing an interface card, you must prepare the slot
for the interface card's form factor.
The following Cisco access routers may require interface card slot preparation prior to installation of the
interface card:
•
•
OL-12842-01
6
Number 1 Phillips screwdriver or a small flat-blade screwdriver
ESD-preventive wrist strap
(For routers using DC power) Tape to secure DC circuit breaker handle
(For certain Cisco access routers) Voice network module for voice interface card installation
On some Cisco access routers, voice interface cards must be installed in voice network modules
before being installed in the router. An additional network module or WAN interface card must be
installed in the router to provide connections to an IP LAN or WAN.
Voice network modules are required for voice interface card installation in the following routers:
– Cisco 2600 series
Cisco 3600 series
–
Cisco 3700 series
–
For information on installing interface cards on network modules, see the
Interface Cards in Cisco Network Modules" section on page
Cisco 2800 series routers
Cisco 3800 series routers
Installing Cisco Interface Cards in Cisco Access Routers
For Cisco 2800 Series and Cisco 3800 Series Routers
Install the interface card. (See the
8.) Single-Wide Interface Cards" section on page 15
the "Installing Double-Wide Interface Cards" section
on page 16.)
Install blank faceplates where appropriate. (See the
"Removing Blank Faceplates" section on page
"Installing
"Installing Cisco
18.
or
8.)