Cisco 1601 - Router - EN Hardware Installation Manual page 148

WIC-1ENET Interface Card
•
•
•
•
•
•
•
•
•
•
•
•
WIC-1ENET Interface Card
This section describes how to connect the Cisco 1-port Ethernet interface card supporting 10BASE-T
Ethernet (WIC-1ENET), and contains the following sections:
•
•
•
The 1-port Ethernet interface card provides the router with additional Ethernet interfaces that can use
the functionality of the Cisco IOS software with any type of external broadband modem, such as a cable
modem, or xDSL modem.
Figure 108
Figure 108
WIC-1ENET Interface Card LED
The LNK (physical layer link) LED is on when the Cisco IOS software recognizes the WIC-1ENET card
and the connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off
when operating in half-duplex mode. Additionally, the Activity LED on the front of the router indicates
that data is being transmitted or received on the slot.
OL-12849-01
4
Voice VLANs
General Attribute Registration Protocol (GARP), GARP Multicast Registration Protocol (GMRP),
and GARP VLAN Registration Protocol (GVRP)
Cisco Inter-Switch Link (ISL) tagging (the chip does not support ISL)
Layer 3 on-board switching
Monitoring of VLANs
Multi-VLAN ports network port
Shared STP instances
VLAN-based SPAN
VLAN Query Protocol (VQP)
VTP pruning protocol
Web-based management interface
Remote Monitoring (RMON)
WIC-1ENET Interface Card LED, page 4
WIC-1ENET Requirements, page 5
WIC-1ENET Full-Duplex and Half-Duplex, page 6
shows the WIC-1ENET interface card.
WIC-1ENET Interface Card
S E E M A N
U A L
B E F O R E
L N K
IN S T A L L
A T IO N
F D X
1 0 B T E T
W IC
1 E N E T
H E R N E T
LAN Interface Cards