Cisco 1601 - Router - EN Hardware Installation Manual page 214

Connecting a T1/E1 HWIC to a Network
Connecting a T1/E1 HWIC to a Network
Use straight-through RJ-48C-to-RJ-48C cables to connect T1/E1 ports to RJ-48C jacks. See the
Modular Access Router Cable Specifications
To connect a T1/E1 port to the network, complete the following steps:
Connect one end of the cable to a T1/E1 port on the card.
Step 1
Connect the other end to the RJ-48C jack at your site, as shown in
Step 2
Figure 0-141
T1/E1 port (RJ-48C)
HWI C-
4T1/ E1
Additional References
For additional information, see the following documents and resources.
Related Topic
Regulatory compliance and safety
information
Cisco IOS software website and reference
documentation
Technical documentation, including
feedback and assistance
OL-12851-01
12
Connecting a T1/E1 HWIC to an RJ-48C Jack
CD/L P P3 AL CD/L P P2 AL
CD/L P P1 AL CD/L P P0 AL
Straight-through
RJ-48C-to-RJ-48C
cable
RJ-48C jack
Document Title
Cisco Network Modules and Interface Cards Regulatory Compliance and Safety
Information
Cisco IOS Software
http://www.cisco.com/en/US/products/sw/iosswrel/tsd_products_support_cate
gory_home.html
What's New in Cisco Product Documentation (including monthly listings of new
and revised documents) at
http://www.cisco.com/univercd/cc/td/doc/abtunicd/136957.htm
T1/E1 High-Speed WAN Interface Cards
for pinouts.
Figure
Cisco
0-141.