Cisco 1601 - Router - EN Hardware Installation Manual page 46

Installing Cisco Interface Cards in Cisco Access Routers
Removing Interface Card Slot Dividers
Slot dividers are removed to permit use of double-wide interface cards in modular router slots. To
determine whether you need to install or remove slot dividers on your Cisco access router, see
To remove slot dividers from network module slots from Cisco 2811, Cisco 2821, Cisco 2851, and
Cisco 3825 series routers, perform the following steps:
Remove any installed interface cards and blank faceplates from the router slot you plan to use.
Step 1
Reach into the interface card slots on both sides of the slot divider, and squeeze the two halves of the
Step 2
slot divider together. (See
Figure 24
Step 3 Pull the slot divider straight out of the interface card slot.
To remove slot dividers from network module slots from Cisco 2801 and Cisco 3845 routers, perform
the following steps:
Step 1 Remove any installed interface cards and blank faceplates from the router slot you plan to use.
Step 2 Loosen the retention screw on the slot divider.
Pull the slot divider straight out of the interface card slot.
Step 3
OL-12842-01
14
Figure 24.)
Removing a Slot Divider from a Cisco 2811, Cisco 2821, Cisco 2851, or Cisco 3825
Series Router
Installing Cisco Interface Cards in Cisco Access Routers
Table 6.