Cisco 1601 - Router - EN Hardware Installation Manual page 196

Access Point High-Speed WAN Interface Cards
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Do not operate your wireless network device near unshielded blasting caps or in an explosive
Warning
environment unless the device has been modified to be especially qualified for such use.
Statement 245B
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
Warning
minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Access Point HWIC LEDs
The access point HWIC LEDs are shown in
described in
Table 39
LED
OK
DATA
OL-12854-01
4
Table 39.
Access Point HWIC LEDs
Description
Off if the access point HWIC is administratively shut down or there is no
service set identifier (SSID) configured.
Blinks if an SSID is configured but there is no client associated.
On (solid green) if one or more clients are associated.
Off if the access point HWIC is administratively shut down or there is no SSID
configured.
Blinks if there is activity (sending or receiving packets).
Access Point High-Speed WAN Interface Cards
Figure 132 and Figure 133. The functions of the LEDs are