Cisco 1601 - Router - EN Hardware Installation Manual page 51

Installing Cisco Interface Cards in Cisco Access Routers
Using a number 1 Phillips or flat-blade screwdriver, loosen the screws on the blank interface card
Step 3
faceplate. (See
Figure 27
Save blank interface card faceplates for future use.
Tip
Align the interface card with the guides in the slot on the network module and slide it gently into place
Step 4
until the edge connector is seated into the connector on the module. (See
Figure 28
1
Interface card
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws into the holes
Step 5
on the network module faceplate.
Reinstall the network interface cables and power up the router.
Step 6
The following warning applies to routers that use a DC power supply:
Warning After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8
Figure 27.) Remove the blank faceplate.
Blank Interface Card Faceplate
DO NOT INSTALL WAN INTERFACE
CARDS WITH POWER APPLIED
Installing an Interface Card in a Network Module (Typical)
2 E
2 W W 1
E T H 1
B 1
B 2
B R I
S /T
1
Installing Cisco Interface Cards in Cisco Network Modules
Figure
W O
E T H E R A U I
N E T 0
E N
2
2
2-slot network module
28.)
OL-12842-01
19