Cisco 1601 - Router - EN Hardware Installation Manual page 194

Access Point High-Speed WAN Interface Cards
The wireless operations can be configured by using the Cisco Router and Security Device Manager
Note
(SDM) web-based application, or by using the Cisco IOS command-line interface (CLI). See the
Cisco Router and Security Device Manager (SDM) Quick Start Guide
Wireless Configuration Guide
Dual-mode access point HWIC with two radios: one 2.4-GHz 802.11b/g radio and one 5-GHz
•
802.11a radio. (See
regions for which the interface cards are configured:
–
–
Note
–
Both the single-mode and dual-mode access point HWICs support diversity in the radio antennas. Types
of antennas include swivel-mount dipole, wall-mount, and ceiling-mount antennas.
For regulatory information about the access point HWIC and supported antennas, see the
Note
of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g and 802.11b/g
Radios document.
Figure 132
HWIC.
Although the single-mode access point HWIC has two sets of LEDs, the LEDs on the left side of the
Note
single-mode access point HWIC are nonfunctioning and do not light.
Figure 132
1
HWIC
AP
1 Mounting screws
2 RP-TNC connectors
OL-12854-01
2
for more information.
Figure 133.) The following are the Cisco part numbers and the geographic
HWIC-AP-AG-A—North America
HWIC-AP-AG-E—Europe
Access point HWICs with the 5-GHz 802.11a radio that are used in Europe may be required
to use Dynamic Frequency Selection (DFS) to detect and avoid interfering with radar signals
to comply with that regulatory domain. DFS operates only on routers running Cisco IOS
version 12.4(2)XA or higher.
HWIC-AP-AG-J—Japan
shows a single-mode access point HWIC, and
Single-Mode Access Point HWIC Front Panel
2
LEFT
Figure 133
3 2 1
OK
g
RP
DATA
RIGHT
TNC
4
3 OK LED for the 802.11b/g radio
4 DATA LED for the radio
Access Point High-Speed WAN Interface Cards
or the Cisco Access Router
Declarations
shows a dual-mode access point