Download Configuration; Figure 4.29 System: Download Configuration - Omega iServer MicroServer iTHX-SD User Manual

4.4.7.3 Upgrade (continued)
Either one of the above options will make you the only user on that iServer.
Set the iServer to default settings after the firmware is upgraded.
See Section 4.4.7.2 on how to set the iServer to default settings.
Applying default settings will change the iServer's settings to factory defaults.
If those settings are important to you and you do not want to reconfigure the iServer, you
will need to do the following steps.
From the "System" menu:
1) "Download" the iServer's configuration settings, Section 4.4.7.4.
2) "Upgrade" the iServer with the new firmware, Section 4.4.7.3.
3) Set the iServer to "Default" settings. The iServer's IP address is now
192.168.1.200.
4) "Upload" the same configuration you obtained from step 1 onto the iServer,
Section 4.4.7.5.
After you have successfully upgraded your device, you can verify the firmware
version number on the "Overview" page (see Section 4.4.1).

4.4.7.4 Download Configuration

Clicking on this button will download the configuration file that contains all the settings
stored in the iServer and use it as a reference.
Download
Address http://192.168.1.200
Overview
Network
Configuration
Management
Security
Recording
System
Diagnostics
Log Out
Readings
Reboot Defaults Upgrade
Download Configuration File

Figure 4.29 System: Download Configuration

Web Link Setup
Download Configuration
40
Upload Configuration