Removing Memory - Dell OptiPlex 755 User Manual

6 Replace the computer cover (see "Replacing the Computer Cover" on page 317).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7 Connect your computer and devices to electrical outlets, and turn them on.
8 When the message appears stating that memory size has changed, press <F1> to continue.
9 Log on to your computer.
10 Right-click the My Computer icon on your Windows desktop and click Properties.
11 Click the General tab.
12 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Information Guide
NOTICE:
To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 21.
2 Remove the computer cover (see "Removing the Computer Cover" for your specific computer).
3 Press out the securing clip at each end of the memory module connector.
4 Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the
connector.
316
Memory
.
Product