Table of Contents
Advertisement
3. Slide the solid-state drive into the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
Figure 33. Removing the memory module
Steps
1. Carefully spread apart the securing-clips on each end of the memory-module slot until the memory module pops-up.
2. Slide and remove the memory module from the memory-module slot.
NOTE:
Repeat steps 1 and 2 if you want to remove the other memory module.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
59
Advertisement
Table of Contents
