Removing The Computer Cover - Dell OptiPlex 755 User Manual

3
network adapter
connector
4 network activity light
5
line-out connector
6 line-in/microphone
connector
7 USB 2.0 connectors (6)
8 video connector
9
serial connector

Removing the Computer Cover

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Information Guide
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the computer cover.
1 Follow the procedures in "Before You Begin" on page 21.
2 If you have installed a padlock through the padlock ring on the back panel, remove the padlock.
3 Locate the cover release latch shown in the illustration. Then, slide the release latch back as you lift the
cover.
168
Small Form Factor Computer
To attach your computer to a network or broadband device, connect one end of a
network cable to either a network jack or your network or broadband device.
Connect the other end of the network cable to the network adapter connector on
the back panel of your computer. A click indicates that the network cable has been
securely attached.
NOTE:
Do not plug a telephone cable into the network connector.
For VPro to work, the network cable must be connected to the onboard NIC.
It is recommended that you use Category 5 wiring and connectors for your
network. If you must use Category 3 wiring, force the network speed to 10 Mbps to
ensure reliable operation.
Flashes a yellow light when the computer is transmitting or receiving network
data. A high volume of network traffic may make this light appear to be in a steady
"on" state.
Use the green line-out connector (available on computers with integrated sound)
to attach headphones and most speakers with integrated amplifiers.
Use the blue and pink line-in/microphone connector (available on computers with
integrated sound) to attach a record/playback device such as a cassette player, CD
player, or VCR; or a personal computer microphone for voice or musical input into
a sound or telephony program.
Use the back USB connectors for devices that typically remain connected, such as
printers and keyboards.
Plug the cable from your
NOTE:
If you purchased an optional graphics card, this connector will be covered by
a cap. Connect your monitor to the connector on the graphics card. Do not remove
the cap.
NOTE:
If you are using a graphics card that supports dual monitors, use the y-cable
that came with your computer.
Connect a serial device, such as a handheld device, to the serial port.
For more information, see "System Setup Options" on page 281.
.
VGA-compatible monitor into the blue connector.
Product