1
release tab
4
serial port adapter connector
8 Connect the adapter cable to the PS/2 serial port adapter connector (PS2/SERIAL2) on the system
board (see "System Board Components" on page 172).
NOTE:
See the documentation for the PS/2 serial port adapter for information about the cable connections.
9 Replace the computer cover (see "Replacing the Computer Cover" on page 317.
Removing a PS/2 Serial Port Adapter
1 Follow the procedures in "Before You Begin" on page 21.
2 Remove the computer cover (see "Removing the Computer Cover" on page 168).
3 Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot the
latch until it snaps into the open position.
4 Disconnect the PS/2 serial-port cable from the system board (see "System Board Components" on
page 172).
192
Expansion Cards
2
adapter retention latch
5
serial port adapter system
board connector
(PS2/SERIAL2)
1
3
4
5
3
serial port adapter bracket
2