Esata; Installing Esata Without A Riser - Dell OptiPlex 755 User Manual

11 Replace the computer cover (see "Replacing the Computer Cover" on page 317).
12 Uninstall the adapter's driver. See the documentation that came with the adapter for instructions.

eSATA

eSATA allows for full SATA data transfer rates (3 GB/sec) between a drive and the chipset, approximately
six times the data throughput of USB.
eSATA on your computer also supports hot-plugging. Hot-plugging allows for device detection without
powering down your computer prior to connecting the device to your computer. When a device is
connected, the operating system automatically recognizes the change. However, the computer must be
powered down before removal and/or replacement.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide
NOTE:
To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal
surface on the computer chassis.

Installing eSATA Without a Riser

1 Remove the computer cover (see "Removing the Computer Cover" on page 90).
2 Remove the filler panel for the card slot you are using for the eSATA connector.
3 Mount the bracket into the desired card slot opening.
4 Plug the free end of the eSATA cable into the eSATA connector on the system board (see "System
Board Components" on page 95).
.
123
Expansion Cards