Installing The Air Shroud; Memory; Removing The Memory Module; Installing The Memory Module - Dell YRC3G Owner's Manual

Installing the air shroud

1 Arrange CPU power cables before installing.
2 Place the shroud into its position.
3 Make sure that the two securing holes of the air shroud is completely inserted into the two holes on the middle fan bracket and the
other latch is fixed on the cooler.
4 Press down the shroud to lock it with a click.
5 Install the side cover.
6 Follow the procedure in

Memory

Removing the memory module

1 Follow the procedure in
2 Remove the following:
a side cover
b air shroud
3 Press the memory module retention tabs on each side of the memory module.
4 Lift the memory module out of the memory slot on the system board.
WARNING: Rotating the memory module out of the slot will cause damage to the memory module. Ensure to pull it straight
out of the memory module slot.

Installing the memory module

1 Align the notch on the memory module with the tab on the memory module connector.
2 Insert the memory module into the memory module slot.
3 Press the memory module firmly until the retention tabs click into place.
NOTE: Do not pull the retention levers up. Always press down firmly on the module until the levers lock into place
unassisted.
4 Install the:
a air shroud
b side cover
5 Follow the procedure in
After working inside your computer.
Before working inside your
After working inside your computer
computer.
Removing and installing components 37