Table of Contents
Advertisement
PREPARING THE CAMERA
OPERATING THE MULTI-CONTROLLER
The multi-controller is for selecting an item in the menu, images, and confirmation of selection.
The following set of sample procedures shows the usage of the multi-controller to make selections when the
camera is in the REC mode.
[MENU]
1. Press [ON/OFF] (power button) or [
2. Press [MENU]
3. Press [
] or [
] repeatedly to highlight and select
the desired tab, then press [SET] or [
highlight selector from the tab to the list of settings.
4. Press [
] or [
] repeatedly to scroll through and
select items related to recording images. Then press
either [
] or [SET] to enter the sub-level of settings for
that selected item.
5. Press [
] or [
] repeatedly to move the highlight
selector to your desired setting.
6. Now, depending on your intent to make further
changes/selection of items or apply changes to only one
item, refer to the table below:
Apply the setting, then exit the menu screen.
Apply the setting, then return to item selection in step 4 above.
Apply the setting, then return to tab selection in step 3 above.
SETTING THE LANGUAGE
1. Follow steps 1 to 3 in the section 'Operating the Multi-
controller' to select 'Setup' tab.
2. Press [
] repeatedly to highlight and select
'Language', then press [SET].
3. Press [
] or [
] repeatedly to highlight and select
the desired language.
4. Press [SET] to confirm selection.
] (REC) button.
] to move the
11
[SET]
[ ] [ ] [ ] [ ]
Press [SET]
Press [
]
Press [
]
Press [
] to move back to 'Tab'
selection
Advertisement
Table of Contents
