Canon imagePROGRAF iPF755 User Manual page 596

Network Setting
Conguring the Communication Mode Manually
This topic gives instructions for conguring the communication mode manually.
1.
On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.
5.
Press ▲ or ▼ to select Auto Detect, and then press the OK button.
6.
Press ▲ or ▼ to select Off, and then press the OK button.
The display reverts to the Ethernet Driver menu.
7.
Press ▲ or ▼ to select Comm.Mode, and then press the OK button.
8.
Press ▲ or ▼ to select the communication mode, and then press the OK button.
The display reverts to the Ethernet Driver menu.
9.
Press ▲ or ▼ to select Ethernet Type, and then press the OK button.
10.
Press ▲ or ▼ to select the Ethernet type, and then press the OK button.
The display reverts to the Ethernet Driver menu.
11.
Press ▲ or ▼ to select Spanning Tree, and then press the OK button.
12.
Press ▲ or ▼ to enable or disable spanning tree support, and then press the OK button.
The display reverts to the Ethernet Driver menu.
13.
Press the Menu button.
After the conrmation message is displayed, press the OK button.
The new settings will take effect after the printer restarts.
580 Network Setting