Maintenance; Clean The Fixture - ETC High End Systems SolaWash 2000 User Manual

Zoom
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Zoom wheel is not located in the default position after the reset

Maintenance

CAUTION:
ATTENTION :
l'entretien.
To ensure that the fixture remains in good working condition and does not fail prematurely,
ETC recommends that you perform regular maintenance on the fixture.
Keep the following in mind during regular service and inspection:
• All screws for installing the fixture or parts of the fixture must be tightly connected and
must not be corroded.
• There must not be any deformations to the housing, lenses, rigging, and installation
points (ceiling, suspension, trussing).
• Moving parts must not show any signs of wear and must move smoothly without issue.
• The power supply cables must not show any damage, material fatigue, or sediment.
• If spare parts are required, order only genuine parts from ETC or your authorized ETC
dealer.

Clean the Fixture

1. Clean the inside and outside of the lens regularly using a damp, lint-free cloth to avoid
loss of output due to accumulation of dust/dirt on the lens. Never use alcohol or solvents.
2. Clean the fans regularly to ensure maximum airflow and efficient cooling. This will
ensure that the light source operates in the best possible condition.
Note:
cleaning them. Letting the fans spin while using compressed air could damage the
fans.
20
RISK OF ELECTRIC SHOCK! Disconnect power before servicing.
RISQUE DE CHOC ÉLECTRIQUE! Couper l'alimentation avant
If you use compressed air to clean the fans, hold the fan blades in place while
SolaWash 2000 User Manual