Icom IC-821H Instruction Manual page 41

SCANS 8
Mi Programmed scan operation
@ Push [VFO] to select VFO mode.
© Select the desired operating mode. @Start. ©Stop. M Select VFO mode.
- The operating mode can also be changed while
scanning.
@) Set the desired band's [SQL] open or closed.
- For FM mode, squelch must be closed.
- See page at left for scan condition.
@ Push [SCAN] to start the scan; push [FUNC] then
[SCAN SUB] to start the sub band scan.
- "SCAN" appears while scanning.
© When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume
setting and the squelch condition. [DISPLAY EXAMPLE DURING A SCAN]
- During scan, the [KHz/MHz] switch can be used.
© To cancel the scan, push [SCAN].
@ Set squelch. @ Select operating mode.
NOTE: If the same frequencies are programmed into
the scan edge memory channels P1 and P2, pro-
"SCAN" appears.
grammed scan does not start.
E Memory scan operation
@) Push [MEMO] to select memory mode.
(2) Rotate the desired band's [SQL] to close the ;
squelch. — @Start. ©Stop. D vere
@) Push [SCAN] to start the scan; push [FUNC] then
[SCAN SUB] to start the sub band scan.
- "SCAN" appears.
(@) When the scan detects a signal, the scan stops or
pauses depending on the scan resume setting.
© To cancel the scan, push [SCAN].
NOTE: 2 or more memory channels must be pro-
grammed for memory scan to start. @Close squelch.
Mi Mode select memory scan operation
NOTE: 2 or more memory channels must be pro-
grammed with the same operating mode for select
memory scan to start.
38