Icom IC-821H Instruction Manual page 39

W Call up a call channel
The call channel is a one-touch accessible channel
for recalling your most-often-used frequency. The
transceiver has one call channel for each band (a
total of 2 channels).
e Calling up
@ Select the desired band with the [M/S] or [SUB]
switch.
(2) Push [CALL] to select the call channel.
@) To return to the previous display, push [VFO] or
[MEMO].
W Call channel programming
The following contents can be programmed into the
call channel in the same way as a memory channel.
e Programming
@ Select the desired band with the [M/S] or [SUB]
switch.
@) Push [CALL] to call up the call channel.
@) While pushing [CALL], rotate the tuning dial to
set the desired frequency to be programed into
the call channel.
@ Select the desired operating mode with the [FM]
or [SSB/CW] switch.
-Set the tone frequency, offset frequency, etc., if
desired.
(©) Push [MW] for 2 sec. to program.
CALL CHANNEL /
'OA
Fu VF
45560G.0 :
[A-B torne
or
VFO previous
mode.
FM VFO A
4335650 :
"C" appears when a call channel is selected.
e Operating frequency
e Operating mode
e Duplex direction and its offset frequency
* Tone encoder or optional tone squelch and its tone
frequency.
[EXAMPLE]: Programming 145.50 MHz/FM into the
call channel.
VFO mode
Select the call
channel.
Select the desired
frequency while
pushing [CALL].
Select the mode,
tone, etc. if desired.
(push for 2 sec.)
Call channel is
programmed.
Bp
eep
Beep
Seo
36