Icom IC-821H Instruction Manual page 38

35
6 MEMORY MODE
W Transferring memory contents
This function transfers the memory channel contents
Y NOTE: When you have changed the frequency and
mode in the selected memory channel:
- Displayed frequency/mode are transferred.
- Programmed frequency/mode are not transferred,
and they remain in the memory channel.
- This function cannot be activated from VFO mode.
®© Select a memory channel with the [A] or [V]
'switch.
- The tuning dial can also be used while [MEMO] is
pushed.
@) Push [FUNC] then [MEMO-MrVFO] for 2 sec. to
transfer the contents of the memory channel.
- The contents are transferred to the most recently
used VFO (VFO A or VFO B).
Mi Memory clearing
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
@ Push [MEMO] to select memory mode.
®© Select a memory channel to be cleared with the
[A] or [W] switch.
@) Push [FUNC] then [MW-M-CL] for 2 sec. to clear
the contents.
- The programmed frequency and operating mode
disappear.
@ To clear other memory channels, repeat steps ©
and @).
NOTE: Scan edge channels P1 and P2 cannot
; be cleared.
Mi Scan edge channels
Scan edge channels, P1 and P2, are located be-
tween the memory channel 80 and channel 1. When
operating a programmed scan, the scan operates
between these programmed frequencies.
Programming can be performed in the same manner
as other memory channels.
TRANSFERRING EXAMPLE
Operating frequency : 144.028 MHz/CW (MEMO 19)
Previously used VFO : VFO A
Select memory
channel 19.
{Me VEO}
(ENA) then (MEMO) (push for 2 sec.)
Programmed contents
are transferred.
ee
B
Selecting VFO
mode.
"Bp
eep
Beep
ep
After 2 sec., the
operating band is
shown.
Scan edge
channel P1
Scan edge
channel P2