Advertisement
3 FREQUENCY SETTING
W When first applying power (CPU resetting)
Before first applying power,
make sure all connec-
[POWER]
tions required for your system are complete by referr-
ing to section 2. Then, reset the transceiver using the
following procedure.
NOTE:
Resetting CLEARS
all programmed
con-
tents in memory channels and returns programmed
values in set mode to default values.
(@ Make sure the transceiver power is OFF.
®© While pushing [MW-M-CL], push IN [POWER] to
turn power ON.
- The internal CPU is reset.
- The transceiver displays its initial VFO frequencies
The transceiver displays its initial frequencies.
when resetting is complete.
(The initial frequency and mode depend on version.)
W Initial settings
After resetting the transceiver, set controls and switches as shown in the figure below.
AF (wain) |:
M a x .
CCW |_| [AF œ]: Max.
CCW
CW : Clockwise
[AF mam ]: Max. CC
[AF (su) ]: Max.
CC
CCW: Counterclockwise
[SQL (an) J: Max. CCW
[SQL (sus) |: Max. CCW
NB]: OFF
INB;
oÈ
=
[RF PWR]: Max. CW
t
U
[ATT]: OFF
[MIC]: CENTER
[PREAMP]: OFF | | [AGC]: OFF | | [COMP]: OFF
[COMP/KEY]: CENTER
Turn power ON, then check the display.
lf any of the following indicators appear, turn them OFF as follows:
"SPLIT': BD
nC
"RIT": C8
SUB OFF
NOR]
REV
g |
=
(Gia) then (ae)
then (Fu_)
Lock
"9600": 9600 bps data
pee
"LOCK":
for 2 sec.
mode. See p. 43.
i
"DUP+" or "DUP—:
Advertisement
Need help?
Do you have a question about the IC-821H and is the answer not in the manual?