Icom IC-821H Instruction Manual page 36

33
6 MEMORY MODE
W Memory channels
The transceiver has a total of 160 memory channels.
Each memory channel can be used to store often-
used frequencies and operating modes as well as a
tone frequency, offset frequency, etc.
Push
—_—_—_—_—"—"—X"—_—_—_—__ >
=>)
[A=B]
Push
W Operation on a memory channel
e Frequency and mode, etc. can be changed in a
memory channel. However, they will be cleared if
[MW] is not pushed.
The previous contents
in memory channel 50.
When changing the
frequency.
When [MW] is not pushed
in the above step, select
ch 50 again.
When [MW] is
pushed for 2 sec. in
the above step,
select ch 50 again.
The changed contents
appear.
Memory mode
Each band has
80 memory
a channels.
Scan edge
channels
e Memory channel 6 and channels above have no
contents programmed. The following indication
appears after 2 sec. when selecting these chan-
nels.
When selecting
non-programmed
channels.
After 2 sec., the
display shows the
-assigned band.
e A beep tone sounds when changing the memory
channel. 2 beep tones sound when spot memory
channel is selected.
2 beeps sounds on the spot
memory channel. (p. 24)