Installing The Button Trim Ring - AMX Modero NXD-CV10 Operation/Reference Manual

10. Place the Faceplate back onto the main NXD-CV10 unit. Make sure to align the Microphone, Light,
and PIR Motion sensor locations on the main unit to their respective openings on the Faceplate
assembly.

Installing the Button Trim Ring

The outer No-Button Trim Ring is secured to the Faceplate with plastic latches. In order to re-install the
Button Trim Ring back onto an NXD panel which has had the default Button Trim Ring features
removed; you must first remove the No-Button Trim Ring:
1. To remove the Faceplate, simply pull it away from the panel by gently tugging it outwards until the
entire Faceplate comes away from the panel.
2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches.
3. In a single motion, press down and then outwards on the three Trim Ring latches located along the
top of the internal surface of the Faceplate to begin removing the Trim Ring. Removing the Internal
Faceplate from the panel exposes the pushbuttons openings left from an earlier removal of the
pushbuttons and light pipes.
4. Gently tug along the edges of the No-Button Trim Ring and work your way around the edges to
remove it from the Faceplate (FIG. 36).
Trim
Ring
Latches
(with button openings)
(outside surface shown)
FIG. 36 Removing the No-Button Trim Ring
5. From along the internal surface of the Faceplate, install the six buttons by firmly inserting them into
the button openings until the Button latch secures the button in place (FIG. 36).
6. Install the pair of clear light pipe strips by pushing light pipes over the two black light pipe latches.
7. Grasp the Button Trim Ring on both sides and fit it into the groove along the outside surface of the
Faceplate (made available by the removal of the previous Trim Ring).
8. Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 37).
9. Firmly press down around the Button Trim Ring until all of the latches are securely inserted into
their openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify the Button
Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring
and the outer surface of the Faceplate.
10" Modero Widescreen Touch Panels
Button Trim Ring
Faceplate
CV10 Panel/enclosure
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the inside surface of Faceplate)
Installation
Button latch
37