Installation; Unpacking The Panel; Installing The Internal Components; Installing The No-Button Trim Ring - AMX Modero NXD-CV10 Operation/Reference Manual

Installation

NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an
NXA-BASE/1 battery base) configuration. NXD panels are installed into either a pre-wall surface (using
a CB-TP10 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).
It is recommended that if you are planning on upgrading your panel components
(flash and wireless), you do so before beginning any panel installations.

Unpacking the Panel

1. Inspect and confirm the contents of the shipment box to verify you have all specified parts. Refer to
the Specifications for 10" Widescreen Video Touch Panels section on page 3 for more information
about included accessories and other AMX equipment.
2. Carefully remove the panel from the shipping box.
3. Carefully peel the protective plastic cover from the LCD.
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.

Installing the Internal Components

Installation of the internal components such as the upgraded Compact Flash and the
NXA-WC80211B/CF Wireless card are described in detail within the following sections:

Installing the No-Button Trim Ring

The NXD-CV10 panel is shipped from AMX with a default Button Trim Ring already installed. The unit
is also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring) that
allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with no-
button openings. In order to install this included No-Button Trim Ring, you must first remove the
factory-installed default Button Trim Ring, the six small buttons, and associated two clear light pipes.
1. The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it
away from the panel by gently tugging it outwards until the entire Faceplate comes away from the
panel.
2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 34).
3. In a single motion, press down and then outwards on the three Trim Ring latches located along the
top of the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the
Internal Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the
Internal Faceplate.
4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove
it from the Faceplate (FIG. 34).
5. From along the internal surface of the Faceplate, remove the six buttons by gently bending each
Button latch up and pulling the button outwards.
10" Modero Widescreen Touch Panels
NXA-WC80211GCF 802.11g Wireless Card (FG2255-07) section on page 17.
NXA-CFSP Compact Flash (FG2116-3x) section on page 20.
Installation
35