Protected Setup Page - AMX Modero NXD-CV10 Operation/Reference Manual

These Navigation Buttons are specific to these Modero panels and include panel specific elements
described in the following table:
Protected Setup Navigation Button Elements
G4 Web Control:
Sensors:
Passwords:
Calibrate:
Wireless Settings:
System Settings:

Protected Setup Page

The Protected Setup page (FIG. 94) centers around the properties used by the panel to properly
communicate with the NetLinx Master. Enter the factory default password (1988) into the password
keypad to access this page.
FIG. 94 Protected Setup page-showing default values
10" Modero Widescreen Touch Panels
Press the G4 Web Control button to access the G4 Web Control page where
you can enable or disable display and control of your panel (via the web) by a
PC running a VNC client.
• Refer to the G4 Web Control Page section on page 103 for more detailed
information.
Press the Sensors button to access the Sensors Setup page where you can
modify/monitor both the light and motion sensor settings.
• Refer to the Sensor Setup section on page 105 for more detailed information.
Press the Passwords button to access the Passwords Setup page where you
can specify up to five security passwords. Default password is 1988.
• Refer to the Password Setup Page section on page 108 for more detailed
information.
Press the Calibrate button to access the Calibration page where you can use
the displayed set of crosshairs to calibrate a touch panel.
• Refer to the Calibration Page section on page 109 for more detailed
information.
Press the Wireless Settings button to access the Wireless Settings page where
you can setup the wireless connection parameters used by the
NXA-WC80211B/CF wireless interface card located within the Modero panel.
• Refer to the Wireless Settings Page section on page 109 for more detailed
information.
Press the System Settings button to access the System Settings page where
you can alter the communication parameters of both the NetLinx
Master and Modero panel.
• Refer to the System Settings Page section on page 132 for more detailed
information.
Firmware Pages and Descriptions
Provides access to the panel
firmware pages by enabling the
grey front setup access button:
- Setup page (after a 3 second
press/hold)
- Calibration page (after a 6 second
press/hold)
101