CyberData 011186 Operation Manual page 76

2. On the Autoprovisioning page, you may enter values for the parameters indicated in
Note
Enable Autoprovisioning
Get Autoprovisioning from DHCP
Download Protocol
Autoprovisioning Server (IP Address)
Autoprovisioning Filename
Autoprovisioning Autoupdate 
(in minutes)
Autoprovision at time (HHMMSS)
Autoprovision when idle
(in minutes > 10)
Operations Guide
22.
The question mark icon (
after the Toggle Help button is pressed
Table 2-22. Autoprovisioning Configuration Parameters
Web Page Item
) in the following table shows which web page items will be defined
.
The device will automatically fetch a configuration file, also known
as the 'autoprovisioning file', based on the configured settings
below. Autoprovisioning file templates are provided in the zipped
firmware folders available on the Downloads tab of the product
webpage. See Section 2.4.14.1, "Autoprovisioning"
information.
The device will automatically fetch the provisioning server
address from the DHCP server. DHCP Options 66, 72, and 150
are supported. If all supported options are set on the DHCP
server, the device will use Options 72, 150, and 66 in this
respective order.
Select the protocol to use when downloading autoprovisioning
files. HTTP and TFTP protocols are supported
Enter the IPv4 address of the provisioning server in dotted
decimal notation.
The autoprovisioning filename is the configuration filename. The
default autoprovisioning filename is in the format of 
<mac address>.config.
Supported filename extensions are .config, .txt, and .xml. The
current filename is denoted by an asterisk at the bottom of this
page. Enter up to 256 characters.
The reoccurring time (in minutes) the device will wait before
checking for new autoprovisioning files. Enter up to 6 digits. A
value of 0 will disable this option.
The time of day the device will check for a new autoprovisioning
file. The time must be 6 characters in length and in HHMMSS
format. An empty value will disable this option.
The idle time (in minutes greater than 10) after which the device
will check for a new autoprovisioning file. Enter up to 6 digits. A
value of 0 will disable this option.
Press the Download Template button to create an
autoprovisioning file for the device. See
"Download Template Button"
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930796K
Installing the VoIP Outdoor Intercom
Intercom Setup
Description
for more
Section 2.4.14.2,
CyberData Corporation
69
Table 2-