LIVOLTEK Hyper-2000 User Manual page 65

AC Freq Fault
EPS Volt Fault
EPS Over Load
EPS Short Fault
Inter CKT Fault
Inter CKT Fault
Inter CKT Fault
Inter Temp High
BAT Temp High
BAT Volt Fault
BMS Lost
Low battery
Grid frequency is not
within permissible
range.
Output Voltage
abnormal (Inverter
voltage is higher than
260Vac)
Overload error. The
inverter is overload
110% and time is
up( more than Five time)
EPS output short circuit
BUS Voltage (AC) is too
high.
Over Current fault.
Component failure.
The ambient
temperature inside the
inverter exceeds the
upper limit.
Battery (Lead-Acid)
temperature is not
within permissible
range.
Battery voltage is not
within permissible
range.
BMS Communication
lost.
The battery voltage is
too low.
Check the setting of the safety country,
frequency and the connection of AC
cables.
Contact your
support if the error happens again.
Check if the load power is within the
EPS power range and the AC output
wires are connected well.
Reduce the connected load by switching
off some equipment, and wait for the
recover.
Restart the inverter and contact your
dealer for technical support if the error
happens again.
Check the wires connection. Restart and
contact your dealer for technical support
if the error happens again.
Wait for inverter recovery. Contact your
dealer for technical support if the error
happens again.
Check the air flow of the unit, then close
it and wait for 30mins.
Contact your
support if the error happens again.
Check the environment temperature.
Contact your dealer for technical
support if the error happens again.
Check the spec and quantity of battery
and the connection.
Contact your
support if the error happens again.
Check battery type and communication
of the BMS cable. Restart the inverter
and contact your dealer for technical
support if the error happens again.
Re-charge battery and contact your
dealer for technical support if the error
happens again.
62
dealer for technical
dealer for technical
dealer for technical