LIVOLTEK Hyper-2000 User Manual page 66

Inter CKT Fault
Inter Com Fault
EEPROM Fault
BMS Fault
PAL Com Fault
PAL Multi
Master
PAL SN Fault
PAL HWC Fault
PAL FWC Fault
PAL SLV Fault
MET/CT Fault
Over Current occurs
during battery charging
or discharging.
BUS Voltage is too high
or internal failed
Internal communication
failure (ARM&DSP).
Internal EEPROM
Component (ARM)
damaged.
BMS communication
failure.
Communication faults
between the master and
the slave inerter.
The master-slave
identity of the inverter is
set incorrectly.
The product models or
output power of the two
inverters do not match.
The hardware codes are
not compatible
The firmware codes are
not compatible
Parallel system stop due
to various reasons.
Meter or CT self-check
fault.
Restart the inverter and contact your
dealer for technical support if the error
happens again.
Check the parallel communication cable
and adjust it if need.
Restart the inverter and contact your
dealer for technical support if the error
happens again.
Check the number of the inverters and
adjust it if need.
Check the product model and power of
the parallel inverters and replace it if
there is inconsistent.
Contact your
support if the error happens again.
Contact your
support.
Check the 2 inverters working status.
Restart the inverters and contact your
dealer for technical support if the error
happens again.
Check the power cable connection.
Contact your
support if the error happens again.
63
dealer for technical
dealer for technical
dealer for technical