Operation - Home Decorators Collection CELENE II Use And Care Manual

Operation

PREPARING THE TRANSMITTER
NOTE: Batteries will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of used batteries properly and keep
them out of the reach of children.
□ Remove the battery cover by pressing rmly on the arrow and
sliding the cover off.
□
Install two 1.5V AAA batteries (BB) (included).
□ Replace the battery cover on the remote control (M).
LEARNING PROCESS
NOTE: The dip switch in the battery compartment has been
set on "0" position and paired for your convenience. If you
have two or more fans, please follow steps below to control
each fan independently.
The learning process causes any installed fan within range to
memorize a remote control. Fans can learn ve remotes.
To add a remote to your fan's memory, use the steps below:
□
Ensure AC power to the fan is OFF to begin the learning
process.
□
Slide the dip switch in the battery compartment to the "1"
position.
□
Turn the fan's AC power ON.
NOTE: If installing multiple fans on separate remotes, only
the fan being programmed should have AC power turned ON.
All other fans, even if they have already been programmed,
should have AC power OFF so they do not memorize other
remotes during the learning process. Separate the fan power
switches by approximately 2 meters.
□
Within 60 seconds of turning AC power on, press and release
the "Pairing" button located in the remote's battery
compartment to enter the learning function. Once the fan has
detected the remote controls's frequency, the down light of your
fan, if applicable, will blink, and the fan blades will start to spin.
□ The fan will now accept commands from the added remote.
M
BB
M
13
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS