Operation; Preparing The Transmitter; Learning Process - Home Decorators Collection FENCEHAM Use And Care Manual

Operation

PREPARING THE TRANSMITTER

Batteries will weaken with age and should be
NOTE:
replaced before leaking takes place as this will damage
the remote control. Dispose of used batteries properly
and keep them out of the reach of children.
□ Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
Install two 1.5V AAA batteries (JJ) (included).
□ Replace the battery cover on the remote control (J).

LEARNING PROCESS

NOTE:
The dip switch in the battery compartment has
been set on "0" position as an universal code for your
convenience. If you have two or more fans, please
follow steps below to control each fan independently.
The learning process causes any installed fan within range to
memorize a remote control. Fans can learn five remotes.
To add a remote to your fan's memory, use the steps below:
□
Ensure AC power to the fan is OFF to begin the learning
process.
□
Slide the dip switch in the battery compartment to the "1"
position.
□
Turn the fan's AC power ON.
NOTE:
If installing multiple fans on separate remotes,
only the fan being programmed should have AC power
turned ON. All other fans, even if they have already
been programmed, should have AC power OFF so they
do not memorize other remotes during the learning
process. Separate the fan power switches by
approximately 2 meters.
□ Within 60 seconds of turning AC power on, press and release the
" Pairing" button located in the remote's battery compartment
to enter the learning function. Once the fan has detected the
remote controls's frequency, the down light of your fan, if
applicable, will blink, and the fan blades will start to spin.
□ The fan will now accept commands from the added remote.
J
JJ
To clear all other remotes from your fan's memory, use the steps
below:
□
Ensure AC power to the fan is OFF to begin the learning
process.
□
Slide the dip switch in the battery compartment to the "0"
position.
□
Turn the fan's AC power ON.
□ Within 60 seconds of turning AC power ON, press and release
the "Pairing" button located in the remote's battery
compartment, and your fan will restore to the original setting
and dismiss the other remotes.
LED bar
Scale indicating
fan speed
TM
Comfort Breeze
Warm weather
(Forward)
16
Fan on/off
Increases fan speed
Decreases fan speed
Timer
Cool weather
(Reverse)