Step 4: Installing The Power Supply; Step 5: Pcie Mounting Bracket - SINGULARITY COMPUTERS PowerBoard Phantom 2 ITX Assembly Manual

Step 4: Installing the Power Supply

•
Required x4
•
Parts ATX Power Supply
Grab an ATX power supply and 4x of the #6-32 10mm SO-M male standoffs and secure the power
supply onto the main PowerBoard at the mounting holes marked with "M" on the lower back side
around the power supply cutout. These standoffs will need to be finger tight as the case gains
most of its structural integrity from these mounts. Plug in the included Power Cable to the power
supply now as the Universal Radiator Mount will block access to it later. Some power supplies
have paint build-up inside the threads that make driving in the standoffs difficult. This can be
cleaned by using the mounting screws included with the power supply and a screwdriver. Drive
all 4 mounting screws in and then out to remove the paint.

Step 5: PCIe Mounting Bracket

The installation of a PCIe mounting bracket is optional but needed for dedicated graphics cards.
For systems with only integrated graphics, this step can be skipped, go to Step 5.
The D5 Distribution Plate is only compatible with the Vertical GPU Mount.
•
Required
x2
Parts
•
x10
•
x1
•
x2
•
x2
Revision 1.0
M #6-32 10mm SO-M
X #6-32 117mm SO-M
(Horizontal)
#6-32 0.25" SCR (Vertical)
HPGU (Horizontal)
VGPU1 (Vertical)
VGPU2 (Vertical)
Phantom 2 ITX Case Assembly Manual
•
Power Cable
•
x1 VGPU3 (Vertical)
•
x1 VGPU4 (Vertical)
•
x1 PCIe Gen4 Riser (Vertical)
•
x2 M3 4mm SCR (Vertical)
Page | 7