Omtech PRO 2440 User Manual page 56

3. Use the keys (Z+, Z–) and the arrows to move the laser head to a desired position in relation to the workbed. (U+
and U– are disabled.) To change the way and distance the laser head moves, see 5.8 Manual Adjustment.
4. Once set, tap to return to the origin menu.
5. Tap "Set Origin" to save the settings. To delete and reset a set origin, tap "Cancel origin" and repeat Step 2.
Note that:
The customized origins only work when "Multi-origins enable" is set to "Enable". When a set number of origins is
set, say 4 origins, there will be 5 origins (0–4) for the laser head to start from, with 0 being the coordinates set by
tapping the position mark from the main menu.
Any two of the origins 1–4 can be set the same. For instance, origin 1 and 2 are set the same and they are both
enabled. After the engraving is finished starting from origin 1, the system will automatically start from the same
coordinates with origin 1. However, no one of the customized origins can be set to be the same as the 0 origin.
When all customized origins are disabled, the laser head returns to the 0 origin by default.
When a set of customized origins are enabled, the system will circle through the set sequence of the origins. For
instance, there are 4 customized origins enabled and the engraving has been initiated from the main interface, the
system will circle through the origins in the sequence that they are set.
If the engraving is initiated directly and wirelessly from the control computer and the current position of the laser
head is set as the origin, the laser head will start from the current coordinates regardless of the origins set by tapping
SysCfg >Origin.
52