Laser Head Return; System Reset - Omtech PRO 2440 User Manual

5.8.4 Laser Head Return

Tap "Return" to enter the laser head return menu as shown.
Under "XY return to", there are four options for the laser head's return: ABS position, Not return, Origin pos, and
Docking point.
ABS position: Sets the laser head to return to the mechanical
origin along the X and Y axis.
Not return: Keeps the laser head where it stopped after an
engraving task.
Origin pos: Sets the laser head to the default origin along the X
and Y axes.
Docking point: Sets the laser head to return to a preset X and Y
coordinates.
Under "Z return to", there are three options for the laser head's vertical position.
ABS position: Sets the laser head to return to the mechanical
vertical origin.
Not return: keeps the laser head where it stops after an engraving
task.
Docking point: Sets the laser head to return to a preset Z
coordinate.
After selecting the options for the laser head to return, tap OK to return the laser head. As this happens, the system
should be showing the status of the X, Y, and Z return at the bottom of the menu as shown above. To stop, tap "Stop".

5.8.5 System Reset

Tapping "Reset" resets the system and modifications.
48