Table of Contents
Advertisement
8. Set the engraver origin to "Rear Right" and click "Next".
9. Confirm your configuration and click "Finish" to close
the pop-up.
10. Click the device drop list in the lower right corner and choose "PRO 2440". The engraver is connected when the
system shows "Ready".
DO NOT connect your computer to the engraver with a network cable. The port marked with "Ethernet"
on the engraver is for internet connection.
30
Advertisement
Table of Contents
Need help?
Do you have a question about the PRO 2440 and is the answer not in the manual?