Table of Contents
Advertisement
DI-1162 Remote Access Router
Range – this is the range of contiguous local addresses above (and
including) the base Local IP.
State – this toggles the enable, disable, for this NAT entry.
Dynamic NAPT
This screen (below) is how the NAT IP Pool appears, if Dynamic
NATPT was chosen for the Translation Mode parameter. Each entry,
in this configuration, can be used to map a single global address and
multiple, contiguous local addresses to each other.
All of the parameters are the same as in Dynamic NAT, except the
Global IP is a solitary, global address.
Global IP – this is a single, globally unique IP Address of the
global interface (the interface to which it is assigned, in this case,
one of the WAN interfaces) that is valid on the Internet.
Configuration and Management
85
Advertisement
Table of Contents
