Table of Contents
Advertisement
DI-1162 Remote Access Router
LED
STATUS/ FUNCTION
Power
Lights whenever the router is plugged in, turned on, and thus
receiving power.
Diag
Lights during the startup POST test.
Boot
Lights briefly during startup after the PROM program has
executed. Indicates a successful boot up.
Run
Should be slowly blinking if the router is functioning properly.
10/100
This LED is ON for a 100Mbps link, and OFF for a 10Mbps
link.
Link/Act
This LED is ON to show a good link to the LAN, and quickly
flashes to show communication activity on the line.
LAN
Full/Half
This LED is ON for a full-duplex connection, and OFF for
half-duplex.
Col
The LED flashes to show transmission collisions on the line.
Ready
This LED is ON to show a good modem or CSU/DSU link to
WANs
the WAN port.
1 & 2
Act
This LED flashes to show communication activity on the line.
Ready
This LED is ON to show a good modem or CSU/DSU link to
the WAN module, or a good link to the LAN port module.
Module
Act
This LED flashes to show communication activity on the line.
10
Installation
Advertisement
Table of Contents
