Table of Contents
Advertisement
DI-1162 Remote Access Router
Make sure both the WAN device(s) and the router are turned OFF
when making these connections.
Step 6 – Plugging in All Devices
Plug the 100~240V AC/DC power cord into the power jack on the
router's rear panel and into a power strip or grounded wall outlet.
At this point in the installation, you may plug in and power on all other
devices. Do not power on the router yet.
Step 7 - Powering Up the DI-1162
After all the devices are powered up, the DI-1162 can be turned ON.
The router will perform a POST (Power On Self Test). It is during this
POST procedure that the PROM Configuration Menu can be accessed.
The router is now able to use the LAN and WAN ports.
The router must be further configured for managing your network. This
can now be done by using the console, the included Windows-based
Configuration Utility or Telnet.
For more information about configuring or managing the router, please
refer to the next chapter – Configuration and Management.
Installation
25
Advertisement
Table of Contents
